DOF // 6 · LINK // ESP-NOW
FILTER // SMOOTHED · CLAMPED
MODE
GRIPPER
Mode:1 | Grip:Open
← ProjectsY-01 · YouTube

Robotic Arm

From the video “I built a Robotic Arm because my real one is lazy”. A 3D-printed, six-servo arm — gesture-controlled over ESP-NOW, then driven from an on-screen gamepad.

MG996R × 3SG90 × 3NODEMCUESP32-C3MPU-6050ESP-NOW
SCROLL TO BUILD
SCROLL — 8 CHAPTERS
02
From the footage

On the bench

PICK AND PLACELOOP · MUTED
Assembled arm
Assembled arm01
Servo bench test
Servo bench test02
Wiring it up
Wiring it up03
Gamepad control
Gamepad control04
Pick and place
Pick and place05

The stack

Joints: three MG996R metal-gear servos for the base, shoulder and elbow; three SG90 micro servos for wrist pitch, wrist roll and the gear-driven gripper.

Transmitter: an ESP32-C3 reads raw accelerometer and gyro data from an MPU-6050, converts it to roll and pitch, and sends it over ESP-NOW.

Receiver: a NodeMCU (ESP-12E) maps the angles onto six servo targets, then smooths and clamps each one before writing it. The servos run from a bench power supply with a common ground.

Control: gesture mode first, then an on-screen gamepad with a mode switch, a gripper toggle and directional pads.

03
The full video

Watch the build

Next project · 06 / 06Lumin — The Hilt