CHAPTER // I · BUILD // HILT
STATE // FORGING
OFFIGNITINGONIDLE
← ProjectsY-02 · YouTube · Chapter I

Lumin

From the video “Chapter I: Before the Kyber calls — Forging the Hilt”. An electronic, light-and-sound hilt built from a Nano, a DFPlayer Mini, a LiPo power stage, a custom PCB and PVC.

ARDUINO NANODFPLAYER MINITP4056MCP1640KICADPVC
SCROLL TO BUILD
SCROLL — 8 CHAPTERS
02
From the footage

On the bench

FINAL ASSEMBLYLOOP · MUTED
Assembled hilt
Assembled hilt01
Nano + DFPlayer on the breadboard
Nano + DFPlayer on the breadboard02
Sound and LED test
Sound and LED test03
KiCad schematic
KiCad schematic04
Cutting the PVC body
Cutting the PVC body05
Emitter in CAD
Emitter in CAD06
Fitting the grip
Fitting the grip07

Inside the hilt

Control: an Arduino Nano reads the switch on D2 and steps through off, igniting, on and idle, playing the matching sound on a DFPlayer Mini and lighting an RGB LED.

The floating-pin fix: a 10 kΩ pull-down from D2 to GND, plus a 500 ms start-up grace period before any state change is acted on.

Power: a LiPo pouch cell, charged over USB-C by a TP4056 board and boosted to 5 V by an MCP1640.

Board: the perfboard prototype redrawn in KiCad — power interface, sockets for the Nano and DFPlayer, and a gyro header.

Body: white PVC pipe with window cut-outs, a black ribbed grip, black bands, a metal push button with a lit ring, and 3D-printed end pieces.

03
The full video

Watch the build

Next project · 01 / 06MIPS32 Core